top of page

DiGi M2M

Product

Xbee-Pro Adaptor
  • 802.15.4  기반의 모든 무선 접속 지원(ConnectPort™ X gateways  및 XBee modules 과 호환성 제공)
  • 다양한 인터페이스 옵션제공(RS-232, RS-485, USB , Digital/Analog I/O등)
  • 저전력 밧데리 사용 가능

 | Xbee ZB Adaptor

Xbee-Pro Adaptor

General

  • Frequency: 2.4 GHz (ISM)
  • ​Antenna options: Integrated whip antenna

Performance

Transmit power output:

RF data rate: 250,000 bps o Receiver sensitivity:

Networking and Security

  • Indoor/Urban range:  - XBee: Up to 100 ft (30 m)
                                          -  XBee-PRO: 300 ft
  • Outdoor RF line-of-sight range:  - XBee: Up to 300 ft (100 m)
                                                            - XBee-PRO: Up to 1 mile
  • XBee: 1 mW (+1 dBm)
  • XBee-PRO: 60 mW (+18 dBm)
  • XBee: -92 dBm (1% PER)
  • XBee-PRO: -100 dBm (1% PER)
  • RS-232 (DB-9M)
  • RS-232PH (DB-9M); power harvesting version
  • RS-485 (6-position wire terminal block) - Switch selectable between RS-422 half duplex, RS-422 full duplex and RS-485
  • Sensor (RJ-45)

Network topologies  Point-to-Point, Point-to-Multipoint, Peer-to-Peer​

Number of channels

Filtration options  PAN ID, Channel, 264 (64-bit) addresses​

LEDs

  • Power: Glows green when external power is supplied (not active when battery powered to limit power drain)
  • Associate: Glows when unit is connected and associated on an RF network Controls
  • Device reset (internal push button) o Identification (internal push button): Relays identification to ConnectPort X gateway

Serial

  • XBee: 16 channels (Direct Sequence Spread Spectrum)
  • XBee-PRO: 12 channels (Direct Sequence Spread Spectrum)

USB

  • USB 2.0 Full Speed (with ESD protection); connects to host via captive 2-meter cable

XBee 232, 485, Sensor, USB, Analog I/O and Digital I/O

  • Battery: -18° C to 55° C
  • External power: 0° C to 40° C
  • External power (hardened): -35° C to 74° C
  • Operating temperature: -40° C to 70° C
  • Powering options

XBee 232PH

  • Operating temperature: 0° C to 65° C
  • FCC Part 15.247
  • Industry Canada (IC)
  • Europe (CE)
  • EN55022, Class A
  • EN60950
  • RoHS compliant

XBee 232, 485, Sensor, Analog I/O and Digital I/O

  • Externally powered: 9-30 VDC, locking connector
  • Battery powered: 3 internal N cell batteries

XBee USB

  • Bus powered: +5V from USB bus
  • Power consumption during normal operation:
  • XBee: 70 mA
  • XBee-PRO: 70 mA (Rx) and 250 mA (Tx)
  • Power consumption during suspend mode : XBee and XBee-PRO: 200 uA

XBee 232PH

  • Internal battery provides power when unit is operating and recharges from the serial port when in sleep mode
  • Requires a sleep/wake duty cycle as part of its normal operation.
  • Requires a fully functional serial port conforming to the RS-232C standard for optimal operation.
  • Sleep/wake duty cycle requirements will vary based on the current output of serial port
  • Serial ports with more than 14VDC output (rare) are not supported and may cause malfunction
  • Serial ports that provide hard power of 5 to 14VDC on one or more pins will allow the device to operate continually without a sleep/wake cycle

XBee 232, 485, Sensor, Analog I/O and Digital I/O

  • Width: 1.68 in (4.26 cm)
  • Height: 0.99 in (2.53 cm)
  • Length: 3.87 in (9.84 cm)
  • Weight: 2.29 oz (6.50 g)

XBee USB and 232PH

  • Width: 1.80 in (4.57 cm)
  • Height: 0.83 in (2.10 cm)
  • Length: 2.87 in (7.29 cm)
  • Weight: 1.60 oz (45.36 g)

XBee 232, 485, Sensor, Analog I/O, Digital I/O

  • Front/Back

XBee USB, 232PH

  • Interface Options
  • Back
  • Interface Options

Copyright ⓒ 2013 Broadwave Corp. Corp. All rights reserved.

bottom of page